Interior — Veneer

Real wood, half a millimetre thick.

A real wood face for furniture, wall panelling and joinery — natural, dyed, burl, metallic, handcrafted and more. Seventeen species across ten finishes, all sliced from real logs.

What is veneer

A real wood face, sliced from a log.

Veneer is a thin sheet of real wood — about 0.5 to 0.6 mm — sliced off a log and glued to a stable board. It carries the full grain and colour of the species, but costs less, weighs far less, and uses a fraction of the timber a solid plank would.

Our range runs to seventeen natural species — from American White Oak and Burma Teak to Wenge, Padauk and Burl — across ten finishes. Leaves are kept in slicing order on the same flitch, so a matched set stays matched from the drawing to the site, even on a large order.

It puts hard-to-source species onto big surfaces — wardrobes, wall panels, bar backs, boardroom tables — without the weight of solid exotic timber, and without felling a whole tree to clad one wall.

The species

Seventeen natural species.

01WalnutDeep chocolate
02CherryPink-red
03White OakPale honey
04White AshLight cream
05Red OakWarm reddish
06BeechPink-cream
07SapeleRed-brown ribbon
08Burma TeakWarm amber
09PineNordic blonde
10WengeNear-black
11MahoganyDeep red-brown
12MaplePale blonde
13TulipPale green-cream
14EucalyptusHoney rose
15SucupiraRich red-brown
16SantosDeep rose-brown
17PadaukVivid orange-red
Why veneer

Four reasons architects use it.

01
Real timber, every leaf

Not a print, not a laminate. Every leaf is sliced off a real log — you get the grain, the figure and the odd natural mark that come with it.

02
Low-emission glue

Bonded with E1-grade adhesive — the low-formaldehyde standard for indoor furniture and cabinetry. Certificates issued with the order where the project needs them.

03
Lower impact

One log covers far more surface as veneer than as solid planks — so a rare species can clad a whole room off a single tree instead of many.

04
Matched by flitch

Every leaf is tracked back to its flitch. Come back six months later for more of the same run and the grain still lines up.

The comparison

Veneer next to laminate and mica.

Specification
Vrikshat Veneer
Laminate / Mica
Material
Real wood face
Printed paper and resin
Grain depth
Real depth, every leaf different
Printed pattern that repeats
Life in interior use
Refinishable for decades
Replaced when it wears or dates
Refinishable
Yes — polish or re-stain
No — strip out and replace
Carbon footprint
Low — high yield off one log
Higher — resin and paper
Indoor air quality
E1 adhesive available
Varies by product
Start your project

Hold it before you order.

Hold the actual leaves before you commit. Three samples, species of your choice, in the post within 48 hours.

65 years in timber · All-India supply · Call +91 99960 23857 (primary) or +91 99920 23751

Product Enquiry

Share your details and our team will get back with samples, sizes & pricing.