The Hybrid Collection
Vrikshat Hybrid Veneer

Wood meets
other matter.

Real wood veneer with metal, stone, leather or resin set into the face. One panel, more than one material, pressed flat into a single sheet.

18
Signature Designs
0.5mm
Face Thickness
Bespoke
Commissioned
1-of-1
Every Sheet
What it is

One surface,
many materials.

Hybrid veneer is a made-up sheet. We take a wood veneer and set other materials into it — a strip of brass, a band of stone, a run of leather, a line of resin — then press the whole thing flat so it works as one face.

Every sheet is built to a drawing. A boardroom table in walnut with a bronze band running through it. An oak reception desk with a stone strip down the middle. A hotel wall where leather sits flush with the grain. No two sheets are the same, because each one is cut for one job. You send the idea, we cost it, cut it and press it.

The composition stack
Wood VeneerBase
Metal InlayBand
Stone InsertSection
Leather StripAccent
Resin FillDetail
How it is made

Three steps, brief
to finished sheet.

01

Draw & cost

Your drawing or a photo becomes a cut-list. We price the wood and the inlay materials, confirm the layout with you, and sign it off before anything is cut.

→
02

Cut & lay

Every piece is cut by hand to the drawing — the veneer, the metal, the stone, the leather — and set in its place on the backing board.

→
03

Press & finish

The whole sheet is pressed onto MDF or plywood under heat, sanded flush so every material sits level, and finished ready for site. One panel, several materials, one flat face.

Where it belongs

Used where the wall
has to do the talking.

This is not a bulk-order material. It goes where the surface is meant to be the thing people notice — a lobby wall, a feature desk, a one-off piece of furniture.

01Executive Boardrooms 02Hotel Receptions 03Member\'s Clubs 04Luxury Residential 05Flagship Retail 06Statement Furniture 07Bar Fronts 08Yacht Interiors
Technical data

Standard specifications.

Every hybrid sheet is made to order. The numbers below are the defaults — the exact spec is set against your drawing before we cut.

Face thickness
0.5 mm veneer faceInlay materials to specification
Panel size
8 ft × 4 ftCustom sizes to drawing
Base species
All 17 Vrikshat natural speciesThe wood sets the ground, the inlay sets the accent
Inlay materials
Metal, Stone, Leather, ResinEach cut & pressed flush
Substrate
MDF / PlywoodGrades to project requirement
Finish
Raw / UnfinishedLacquer, PU or oil over the composition
Lead time
Project-basedDepends on composition complexity
Packaging
Protective wrapPan-India from Kaithal, Haryana

No two sheets match. Cut the same design twice and the grain falls differently each time — with this material, that is the point.

Commission a composition

Send an idea,
we build the sheet.

Send a photo, a sketch, or just the materials you want paired. We price it, confirm the layout, and press a one-off panel built to your drawing. Pan-India from Kaithal.

Product Enquiry

Share your details and our team will get back with samples, sizes & pricing.