Real wood, half a millimetre thick.
A real wood face for furniture, wall panelling and joinery — natural, dyed, burl, metallic, handcrafted and more. Seventeen species across ten finishes, all sliced from real logs.
A real wood face, sliced from a log.
Veneer is a thin sheet of real wood — about 0.5 to 0.6 mm — sliced off a log and glued to a stable board. It carries the full grain and colour of the species, but costs less, weighs far less, and uses a fraction of the timber a solid plank would.
Our range runs to seventeen natural species — from American White Oak and Burma Teak to Wenge, Padauk and Burl — across ten finishes. Leaves are kept in slicing order on the same flitch, so a matched set stays matched from the drawing to the site, even on a large order.
It puts hard-to-source species onto big surfaces — wardrobes, wall panels, bar backs, boardroom tables — without the weight of solid exotic timber, and without felling a whole tree to clad one wall.
Ten ways to cut and finish.
Same wood, ten different faces — from a plain sliced leaf to a smoked, dyed or inlaid one. Pick a finish and open its page.
Seventeen natural species.
Four reasons architects use it.
Not a print, not a laminate. Every leaf is sliced off a real log — you get the grain, the figure and the odd natural mark that come with it.
Bonded with E1-grade adhesive — the low-formaldehyde standard for indoor furniture and cabinetry. Certificates issued with the order where the project needs them.
One log covers far more surface as veneer than as solid planks — so a rare species can clad a whole room off a single tree instead of many.
Every leaf is tracked back to its flitch. Come back six months later for more of the same run and the grain still lines up.
Veneer next to laminate and mica.
Hold it before you order.
Hold the actual leaves before you commit. Three samples, species of your choice, in the post within 48 hours.
65 years in timber · All-India supply · Call +91 99960 23857 (primary) or +91 99920 23751