Cut and laid
by hand.
Veneer cut into shape by hand and laid into patterns — herringbone, parquet, star, inlay work. Every sheet is cut to a drawing, no two the same.
The artisan's layer.
Handcrafted veneer is veneer cut into shape by hand and laid into a pattern. A machine can press a flat sheet; it cannot lay a hand-cut star across a boardroom table. The pattern is what you are buying.
The patterns — herringbone, chevron, parquet, sunburst, diamond, inlay — come from European marquetry, now cut on real wood faces. Every commission goes through drawing, cutting, assembly, then press onto the substrate. The finished sheet reads as architecture, not cladding.
Six in stock.
Twenty more on request.
Four reasons it reads
as architecture.
A machine-pressed panel repeats. A hand-laid one does not. That difference shows up in a boardroom, a hotel lobby or a residential ceiling — the kind of surface people notice.
Artisan workmanship
Cut and laid by the hands that make it — not stamped from a mould or printed on.
Bespoke patterns
Herringbone, chevron, sunburst, or something drawn for your project — not pulled off a stock shelf.
One of a kind
Even the same pattern cut twice is different — the grain lands differently on every sheet. That is the point of buying hand-laid.
Collaboration ready
We work off your drawing. Send it finished, send it rough, send a reference — we cost from whatever you have.
Where handcrafted belongs.
Standard specifications.
Hand-laid pattern work on a 0.5 mm veneer face, pressed onto an MDF or plywood board. Every sheet commissioned.
Send the drawing.
We build it.
Send a pattern, a reference or a drawing. We quote it, cut it, lay it and press it. Samples go out before you commit to the full order.